73
6
6
Driver assistance system Smart Cruise Control (SCC)
Smart Cruise Control operation
Operating conditions
Smart Cruise Control will operate when
the following conditions are satisfied.
Basic function
僅 The gear is in D (Drive)
僅 The driver's door is closed
僅 EPB (Electronic Parking Brake) is not
applied
僅 Your driving speed is within the oper
-
ating speed range
- 5~110 mph (10~180 km/h): when
there is no vehicle in front
- 0~110 mph (0~180 km/h): when
there is a vehicle in front
僅 ESC (Electronic Stability Control), TCS
(Traction Control System) or ABS is
on, but not controlling the vehicle
僅 Engine rpm is not in the red zone
僅 Forward Collision-Avoidance Assist
brake control is not operating
When your vehicle is stopped with a
vehicle in front of you, Smart Cruise
Control will turn on if the brake pedal is
depressed.
Overtaking Acceleration Assist
Overtaking Acceleration Assist will oper
-
ate when the left turn signal indicator is
turned on while Smart Cruise Control is
operating, and the following conditions
are satisfied:
僅 Your driving speed is above 40 mph
(60 km/h)
僅 The hazard warning flasher is off
僅 A vehicle is detected in front of your
vehicle
僅 Deceleration is not needed to main
-
tain distance with the vehicle in front
僅 When the left turn signal indicator is
turned on while there is a vehicle
ahead, the vehicle may accelerate
temporarily. Pay attention to the road
conditions at all times.
僅 Regardless of your country's driving
direction, Overtaking Acceleration
Assist will operate when the condi
-
tions are satisfied. When using the
function in countries with different
driving direction, always check the
road conditions at all times.
Smart Cruise Control display and
control
Basic function
Smart Cruise Control will be displayed as
below depending on the status of the
function.
You can see the status of Smart Cruise
Control operation in the Driving Assist
view on the cluster. Refer to "LCD dis
-
play" on page 4-68.
僅When operating
Operating
To Next Page
Loading...
Need help?
General
