29
3
3
Safety features of your vehicle Child Restraint System (CRS)
Installing a Child Restraint Sys
-
tem (CRS)
After selecting a proper child seat for
your child, check to make sure it fits
properly in your vehicle.
Follow the instructions provided by the
manufacturer when installing the child
seat. Note these general steps when
installing the seat to your vehicle:
僅
Properly secure the child restraint
to the vehicle.
All child restraints
must be secured to the vehicle with
the lap part of a lap/shoulder belt or
with the LATCH system.
僅
Make sure the child restraint is
firmly secured.
After installing a child
restraint to the vehicle, push and pull
the seat forward and from side-to-
side to verify that it is securely
attached to the seat. A child restraint
secured with a seat belt should be
installed as firmly as possible. How
-
ever, some side-to-side movement
can be expected.
僅
Secure the child in the child
restraint.
Make sure the child is prop
-
erly strapped in the child restraint
according to the manufacturer
instructions.
Lower Anchors and Tether for
Children (LATCH) system
The LATCH system holds a child
restraint during driving and in an acci
-
dent. This system is designed to make
installation of the child restraint easier
and reduce the possibility of improperly
installing your child restraint. The LATCH
system uses anchors in the vehicle and
attachments on the child restraint. The
LATCH system eliminates the need to
use seat belts to secure the child
restraint to the rear seats.
Lower anchors are metal bars built into
the vehicle. There are two lower anchors
for each LATCH seating position that will
accommodate a child restraint with
lower attachments.
To use the LATCH system in your vehi
-
cle, you must have a child restraint with
LATCH attachments.
The child seat manufacturer will provide
you with instructions on how to use the
child seat with its attachments for the
LATCH lower anchors.
LATCH anchors have been provided in
the left and right outboard rear seating
positions. Their locations are shown in
the illustration. There are no LATCH
anchors provided for the center rear
seating position.
LATCH Lower Anchors
Never attempt to attach a LATCH
equipped seat in the center seating posi
-
tion. LATCH lower anchors are only to be
used in the left and right rear outboard
seating positions. You may damage the
anchors or the anchors may fail and
break in a collision if the seat is in the
center seating position.
The lower anchor position indicator sym
-
bols are located on the left and right rear
ODL3A031097
To Next Page
Loading...
Need help?
General
