47
6
6
Driver assistance system Blind-Spot Collision-Avoidance Assist (BCA)
Always pay attention to road and driv
-
ing conditions while driving.
僅 Driving on an inclined road
Blind-Spot Collision-Avoidance Assist
may not operate properly when driv
-
ing on a slope. Blind-Spot Collision-
Avoidance Assist may not detect the
vehicle in the next lane or may incor
-
rectly detect the ground or structure.
Always pay attention to road and driv
-
ing conditions while driving.
僅 Driving where the heights of the lanes
are different
Blind-Spot Collision-Avoidance Assist
may not operate properly when driv
-
ing where the heights of the lanes are
different. Blind-Spot Collision-Avoid
-
ance Assist may not detect the vehicle
on a road with different lane heights
(underpass joining section, grade sep
-
arated intersections, etc.).
Always pay attention to road and driv
-
ing conditions while driving.
僅 When you are towing a trailer or
another vehicle, make sure that you
turn off Blind-Spot Collision-Avoid
-
ance Assist.
僅 Blind-Spot Collision-Avoidance Assist
may not operate normally if interfered
by strong electromagnetic waves.
僅 Blind-Spot Collision-Avoidance Assist
may not operate for approximately 15
seconds after the vehicle is started, or
the front view camera or rear corner
radars are initialized.
This device complies with Part 15 of
the FCC rules.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interfer
-
ence received, including interference
that may cause undesired operation.
CAUTION TO USERS
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's author
-
ity to operate the equipment.
ODL3A052209
ODL3A052257
To Next Page
Loading...
Need help?
General
