Driver assistance system
806
Smart Cruise Control (SCC)
僅 The front vehicle's speed is fast or
slow
僅 With a vehicle in front, your vehicle
changes lane at low speed
僅 The vehicle in front is covered with
snow
僅 Unstable driving
僅 You are on a roundabout and the
vehicle in front is not detected
僅 You are continuously driving in a cir
-
cle
僅 Driving in a parking lot
僅 Driving through a construction area,
unpaved road, partial paved road,
uneven road, speed bumps, etc.
僅 Driving on an incline road, curved
road, etc.
僅 Driving through a roadside with trees
or streetlights
僅 Your vehicle is moving unstable
僅 The adverse road conditions cause
excessive vehicle vibrations while
driving
僅 Your vehicle height is low or high due
to heavy loads, abnormal tire pres
-
sure, etc.
僅 Driving through a narrow road where
trees or grass are overgrown
僅 There is interference by electromag
-
netic waves, such as driving in an area
with strong radio waves or electrical
noise
僅 Driving on a curved road
On curves, Smart Cruise Control may
not detect a vehicle in the same lane,
and may accelerate to the set speed.
Also, vehicle speed may rapidly
decrease when the vehicle ahead is
detected suddenly.
Select the appropriate set speed on
curves and apply the brake pedal or
accelerator pedal according to the
road and driving conditions ahead.
Your driving speed can be reduced
due to a vehicle in the adjacent lane.
Apply the accelerator pedal and select
the appropriate set speed. Check to
be sure that the road conditions per
-
mit safe operation of Smart Cruise
Control.
OHM051527
OHM051530
To Next Page
Loading...
Need help?
General
