M0290-01Model 4900
2-32 Rev. 8/19
TM
Machine Operation
Row Marker Lengths
12 Row 30" 360" (914.4 cm)
16 Row 30" 480" (1,219.2 cm)
24 Row 30" 720" (1,828.8 cm)
ROW MARKER LENGTH AND DISC BLADE ADJUSTMENT
1. Multiply number of rows by the average row spacing in inches to determine total planting width.
2. Lower planter and row marker assembly to ground.
3. Measure from planter center line to a point where blade contacts ground.
4. Adjust row marker extension so distance from marker disc blade to center line of planter is equal to total planting
width. Adjust right and left row marker assemblies equally and securely tighten clamping bolts.
Marker disc blade is installed with concave side facing inward. Spindle assembly is slotted so hub and blade can be
angled to throw more or less dirt.
5. Loosen hardware and move assembly as required.
6. Tighten bolts to specified torque.
7. Do a field test to ensure markers are properly adjusted.
NOTE: A notched marker blade is available from Kinze through your Kinze Dealer for use in more severe no
till conditions.
Row Marker Disc Blade Angle Adjustment
Loosen hardware to
adjust blade angle.
Concave side faces
towards planter.
Loosen hardware to
adjust marker length.
Depth band
Setting marker disc blade assembly at a
sharper angle than needed adds stress
to row marker assembly and shortens
bearing and blade life. Set blade angle
only as needed to leave a clear mark.
NOTICE
To Next Page
Loading...
