Section 1
Introduction
20412914
8-2012/Rev 09
1-7
Table 1-2
Warning Label Precautions
4
High pressure water and/or hydraulic pressure can
remain in the system even when the pump has been shut
off. All pressure can be safely bled from the system by
opening the high pressure cutting water valve for a few
seconds after shutting off the pump.
Pressing the emergency stop button turns the control
power to the intensifier off, stops the pump and bleeds
the high pressure water through the safety dump valve.
Depressurization of the high pressure system creates a
loud hissing sound when the dump valve opens. The
sound fades quickly as the pressure drops.
P/N 05098017
5
All personnel involved in the installation, operation
and/or service of the intensifier must carefully read,
understand and follow the procedures in this manual to
avoid creating unsafe conditions, risking damage to the
equipment, or personal injury.
P/N 20415794
Safety precautions and warnings for specific procedures are emphasized throughout this manual
as illustrated in the following examples. These precautions must be reviewed and understood by
operating and maintenance personnel prior to installing, operating or servicing the machine.
Adherence to all Warnings, Cautions and Notes is essential to safe and efficient service and
operation.
Warnings emphasize operating or service procedures, or conditions that can result
in serious personal injury or death.
Cautions emphasize operating or service procedures, or conditions that can result in
equipment damage or impairment of system operation.
To Next Page
Loading...
Need help?
General
