Knapen Trailers K200 - Page 30

30
5 Use moving oor trailer
5.1.2 Before loading/unloading
Check the following before you start loading or unloading.
Switch on the hydraulics (PTO)
Switchonthelightingforthepowersupplyofthemovingoorsystem.
Considercarefullywhatyouwantthesystemtodo.Loadorunload?
When loading, ensure that the load is not pressed against the head board.
Keep a safe distance from the vehicle, see chapter 3 and operate it
with the wired remote control or the Knapen Trailers remote control.
4m 1,5m
Forthetransportofsharporne-grainedproductsitisadvisabletouseaoor
sheettoprotectthemovingoor.
The passage for the product to be transported must be free.
Make sure the doors are open.
Check immediately, and always, if the product is moving in the desired direction
Movable bulk head
Regardless of the type of load, the movable bulk head (1) must be pushed to the
front.
The movable bulk head can easily be pushed to the front in the trailer.
Make sure the sheet (2) that is attached to the movable bulk head is placed on
themovingoorbeforestartingtoload.
When loading the goods, ensure the load does not exert too much pressure on
the head board. Pay special attention
ifpalletsareloaded.(loadingusingoorsystem)
1
2