Knapen Trailers K200 - Use of the Knapen Trailers remote control

43
User Manual EN | v201906
5.8 Use of the Knapen Trailers remote control
TheKnapenTrailersremotecontrolissuppliedinthreeversions,the5-function,the6-functionandthe12-function.
The receiver on your trailer is powered by the lighting. The lighting must therefore be switched on to operate the
system.
Intheeventofamalfunctionoftheremotecontrol,seeCh7.5
5.8.1 Operation via the remote control
The remote control uses two LED indicators, one red and one green.
The table below shows the meaning.
LED Light behaviour Meaning
Blinking Button pressed
Blinks every 5 seconds Radio communication started
Blinks every 3 seconds Button held down
Blinks every second Radio communication active
Blinks twice a second Radio communication disconnected
Blinks every second when a button is
held down
Battery almost empty
Lit continuously when a button is held
down
Battery empty (replace)
Symbol
No function
Light sensor
Overview buttons and functions
This shows the buttons and functions each remote control has. Each function is described.
Button Function Mode 5-Function 6-Function
START
SYSTEM START -
STOP
SYSTEM STOP -
FLOOR "LOAD” M
FLOOR "UNLOAD” L
LIGHTS1 L
OPEN
OPEN M
AXLE M
CLOSE
CLOSE M