Knapen Trailers K200 - Maintenance and cleaning; Trailer maintenance instructions

54
6 Maintenance and cleaning
6 Maintenance and cleaning
6.1 Trailer maintenance instructions
Observe the following safety regulations:
The hydraulic system must be switched off during cleaning
Let the hydraulic system cool down to 40 ° C or lower (lukewarm) before cleaning
Wear safety footwear, safety goggles and safety gloves
Thoroughly inspect all parts for damage or defects
Make sure no water enters the hydraulic system
Whenthetraileriscleanedwithapressurewasherorwithanormaljetofwateravoidspraying
the bearings, the hydraulic installation and the switch panels, control element and electrical
installation.Thesepartsareonlysplash-proofandcannotbesprayedondirectly
Onlyusethespeciedcleaningagentsforcleaningthemachines.
6.1.1 Checking and/or cleaning parts
Front
daily weekly monthly annually
Air couplings (see Ch 4.2) x
Hydraulic couplings and hoses (see Ch 4.6) x
Protective lids on hydraulics connectors (see Ch 4.2.) x
Ladder and supports x
Chain and lock mechanisms (see Ch 5.9) x
Platform for damage (see Ch 5.9) x
Lighting/electricity
daily weekly monthly annually
Lights front x
Side lights left x
Side lights right x
Lights rear x
Lights upper beam x
Side
daily weekly monthly annually
Side guard x
Side guard, locking pin positioned correctly x
Toolbox (see Ch 4.12) x
Control Box air suspension (see Ch 4.9) x
Block for straps (see Ch 5.9.2) x
Door retainer (see Ch 5.1.8) x
End stop blocks at doors x
Landing legs operation (see Ch 4.3) x
Lubricate landing legs x
Back/rear
daily weekly monthly annually
Smooth operation of protection plate and lockings x
Smooth operation of doors x
Closing of doors (see Ch 5.1.7.) x
Operation/condition pneumatic locking device (see Ch 6.4) x
Door seals, presence, condition and position x
Pull-outladderforsafetyandoperation(seeCh5.1.6) x