72
7 Troubleshooting
7.5 Troubleshooting Knapen Trailers remote control
The remote control consists of a transmitter and receiver
Transmitter
5/6 functions
Receiver
5/6 functions
Transmitter
12 functions
Receiver
12 functions
Malfunction Cause Solution
The system does not
respond at all to its
operation.
The green LED does not
light up when a button
is pressed.
No power to the receiver
Check whether the lighting is on.
Check whether the emergency button is deactivated.
Remote control is
malfunctioning
Check its operation with the emergency control 7.5.2
Transmitter and receiver
are not paired.
Transmitter and receiver pairs.
Fuse is defective Check and replace the fuse in the receiver.
The green LED does not
light up when a button
is pressed.
Batteries empty Replace the batteries in the transmitter.
Polarity of the batteries in
the transmitter is incorrect.
Check if the batteries are installed correctly.
The system does not
respond consistently to
the operation
Batteries almost empty Voltage too low, replace batteries
Battery 1.2 v. voltage is too
low
Use 1.5 v batteries
Transmitter is used beyond
the maximum range
Get closer to the receiver.
Error in cabling to intended
function.
Check the cabling to the intended function.
To Next Page
Loading...