65
Measurement
Preparation
The Measurement Preparation section explains preparations (instrument setting, zero calibration) that
are required prior to measurement.
Zero calibration
Explains the zero calibration method.
(Measurement cannot be performed if zero calibration is not completed.)
P. 66
Measurement Condition Settings
Explains the various settings according to the purpose of measurement
Sync Mode / Meas Speed / Trigger Mode / Interval Meas / Interval Alert / JEITA freq
resolution
P. 68
Selecting a Probe No.
Explains how to select the probe whose measured value is to be
displayed.
P. 79
To the Settings section
* Go to the Measurement section if performing measurement using Konica Minolta’s calibration standard.
CA-DP40
Measurement
Preparation
To Next Page