Konica Minolta CA-410 - Calibration;Settings

80
Calibration/Settings
This section explains settings that must be configured according to measurement method.
The setting method varies according to the measurement method.
From the Measurement Preparation section
Outline of the Calibration/Settings Section
Explains measurement method types and settings that must be configured. (Check which
settings must be configured.)
P. 81
Before Configuring Each Setting
Gives detailed explanations on calibration channels common to each setting and target
values.
P. 82
When performing
measurement using
Konica Minolta’s
calibration standard
When performing
measurement using
user calibration
Setting/Changing the
Target*
1
Explains how to set/change
the target value.
1. Setting/Changing the
Target Value by
Measurement
2. Setting/Changing the
Target Value by Entering
Values
User calibration
Gives detailed explanations
on user calibration and
explains the execution
method (as well as setting
target values).
P. 96 PP. 84–87
To change the target value after user
calibration: Refer to page96 “Setting/
Changing the Target”*
1
.
•TosetanID:
page 92 “Setting an
ID”*
2
.
Other Settings
Explains how to set an ID*
2
.
Settings Check Method
Settings can be checked from
Menu area 3.
To the Measurement section
P. 92 P. 53