Konica Minolta CL-70F - Page 81

68
5. Measuring Light Sources [Measurement Screen]
CAUTION
●
Do not trigger ash while skin or other objects are in contact with the ash
tube. Do not touch the ash tube after repeated ashes. (It may cause
burns.)
●
Do not trigger ash while near the eyes of people or animals. (It may
temporarily affect vision.)
●
The ash may be triggered suddenly. Because there is the possibility of
burns or negative effects on vision, please handle with care.
NOTICE
●
If the ash output power is too weak compared to the surrounding light, the
meter, when set in cordless mode, may not detect the ash output. In this case,
use "5-4 Measurement in Cord (PC) Flash Mode". (
¨
P69)
●
Pulsed light sources such as uorescent lights or special lighting could cause
the meter to take cordless ash measurements in rare cases. In these situations,
use "5-4 Measurement in Cord (PC) Flash Mode". (
¨
P69)
●
If the Light Receptor
1
detects a sudden and bright change in lighting
intensity, the meter may mistakenly take a measurement. To avoid this, take "5-4
Measurement in Cord (PC) Flash Mode". (
¨
P69)
●
Do not use Cordless Flash Mode for sources which gradually increase to peak
power, such as traditional ash bulbs, as they cannot be detected and measured.
Be sure to take "5-4 Measurement in Cord (PC) Flash Mode". (
¨
P69)
●
When using Cordless Flash Mode, the LCD screen illumination dims during
measurement, and the LCD is illuminated for 3 seconds after measurement. To
cancel standby mode, touch the screen or press the Menu Button
6
.
●
In the Cordless Flash mode, the measured color temperature may change
depending on the shutter speed set for ash measurement and the amount of
ambient light present when the measurement is made.
NOTE
●
When using the meter in Cordless Flash Mode, it is possible to mount the meter to a
light stand, tripod or similar support using the Tripod Socet
0
.
●
[Over] or [Under] will be displayed if the light source illumination is too bright or not
bright enough, or if the color temperature is out of the measurement range, when the
Measuring utton is pressed. When the color temperature is outside the calculation
range, --- is displayed. In this case, adust the brightness or color temperature of light
source, or switch the light range. 
¨
P78)