Konica Minolta CS-3000HDR User Manual

67
Setting
3. Press either or key to select [USER
CAL] and then press
ENTER
key.
The MENU - OPTION - USER CAL (for selection of
calibration channel) screen appears on the LCD.
The calibration channel number and compensation
coefficient ID (maximum of 10 characters) are
displayed. In the case of Ch00, “NON” is displayed.
MENU
OPTION
(
1/2
)
USER CAL
CAL NO.
OFF
5. Press
ENTER
key.
When the calibration channel is set, the MENU -
OPTION screen appears again on the LCD.
If a calibration channel without set correction factor is
selected, it cannot be set.
By pressing the
ESC
key, the setting is canceled and
the MENU - OPTION screen appears again on the LCD.
The calibration channel setting is saved even after the
power switch is turned OFF (O).
NEGATIVE VALUE
NO PROC
CLOSE UP OFF
EXT-ND
OFF
USER CAL 03
OPTION
(
1/2
)
MENU
6. Press
ESC
key.
The MENU screen appears again on the LCD.
7. Press
ESC
key.
The MEAS screen appears again on the LCD.
MEAS SNGL
UC03
SPD
Nrm
CMF
2 ˚
SYN
[
Hz
]
59.94
ACC
Non
cd
m
2
Lv 63.60
0 . 4015
0 . 4061
x
y
1 ˚
4. Press either or key to select a
channel.
Press key for a larger number.
Press
key for a smaller number.
The calibration channel selectable range is OFF and 01 to 10.
MENU
OPTION
(
1/2
)
USER CAL
CAL NO.
03
AB-X
2. Press either or key to select
[OPTION] and then press
ENTER
key.
The MENU - OPTION screen appears on the LCD.
The current set contents are displayed in the [USER
CAL] item.
NEGATIVE VALUE
NO PROC
CLOSE UP OFF
EXT-ND
OFF
USER CAL OFF
OPTION
(
1/2
)
MENU

Konica Minolta CS-3000HDR Specifications

General

Brand	Konica Minolta
Model	CS-3000HDR
Category	Measuring Instruments
Language	English