KONRAD 520 - Tools Recommended For Installation

500 SERIES INSTALLATION MANUALJULY 2016 PAGE 5
Konrad has an installation tool kit available for purchase.
The following is a complete list of all items included in the kit.
Installation Tool Kit
30 – 190
NOTE: Additional tools may be required.
Tool box
3/8 in. Drill
13/64 in. Drill Bit (pilot for lag screws)
Jig Saw
Jig Saw Blades (2)
3/8 in. Drive Ratchet (quick release)
3/8 in. Drive 3 in. Extension
3/8 in. Drive 6 in. Wobble Extension
3/8 in. Drive to 1/4 in. Drive Reducer
1/4 in. Drive 1/4 in. Socket
3/8 in. Drive to 5/16 in. Socket
3/8 in. Drive 7/16 in. Socket
3/8 in. Drive 1/2 in. Deep Socket
3/8 in. Drive 1/2 in. Socket
3/8 in. Drive 9/16 in. Socket
3/8 in. Drive 5/8 in. Deep Socket
3/8 in. Drive 3/4 in. Socket
3/8 in. Drive 3/4 in. Deep Socket
3/8 in. Drive 5/16 in. Allen Head Socket
5/16 in. Combination Wrench
3/8 in. Combination Wrench
7/16 in. Combination Wrench
1/2 in. Combination Wrench
9/16 in. Combination Wrench
5/8 in. Combination Wrench
11/16 in. Combination Wrench
3/4 in. Combination Wrench
1-7/16 in. Combination Wrench
8 in. Adjustable Wrench
4 in. Flat Blade Screwdriver
6 in. Flat Blade Screwdriver
4 in. #2 Phillips Screwdriver
6 in. #3 Phillips Screwdriver
6 in. #2 Phillips Bit
6 in. #3 Phillips Bit
7 in. Vice Grips
6 in. Slip Joint Pliers
12 in. Flat Blade Pry Bar
15 in. Pry Bar
Diagonal Side Cutter
1-1/4 in. Putty Knife
Center Punch/Scratch
100 Grit Sandpaper (5) pcs.
Black Permanent Marker
2 lb. Hammer
Breathing Mask
Rasp File (Flat/Half Round)
Assortment of Cable Clamps (15)
Screws for Cable Clamps (15)
Pilot Drill 4/Cable Clamp Screws 3/32 in.
8 in. Cable Ties (15)
Horseshoe Magnet
Tools Recommended for Installation