KONRAD 520 - Step 11: Trim;Lift Pump Filling;Bleeding Procedure

500 SERIES INSTALLATION MANUALJULY 2016 PAGE 47
11.3 With the drive in the up position, attach the “down” line
to the trim/lift pump.
11.4 Cycle the drive all the way to the down position and then
all the way to the up position. Repeat this step three to four
(3-4) times to purge any remaining air out of the system.
NOTE: Re-check the uid level of the reservoir. Add
uid if necessary.
NOTE: Check entire trim system (inboard and outboard
the transom) for leaks before proceeding.
Step 11: Trim/Lift Pump Filling/Bleeding Procedure (continued)
FIGURE 11D