500 SERIES INSTALLATION MANUAL JULY 2016PAGE 34
7.5 Place bushing (10-443), retaining washer (10-444) and
nylock nut (10-314) on forward and aft anchor pins.
Tighten the forward nuts to 20 lb ft (27 Nm). Tighten
the aft nut so the retaining washer (10-444) bottoms out
on the shoulder of the anchor pin. Make sure at least two
or three (2-3) threads are showing beyond the end of the
nuts.
NOTE: Install all four (4) nylock nuts (10-314) before
tightening nuts completely.
7.6 Remove the red caps from the trim cylinders if they have
not been removed previously (see step 7.4 on page 33
in this manual). The trim cylinders have red plastic caps
in the hydraulic line ports when they are shipped from
Konrad.
7.7 Hook up the four (4) trim lines (from the transom assembly
to the trim cylinders) according to their tags. The line
input on the trim cylinders closest to the transom is up.
NOTE: Ensure to not cross thread the hose’s ttings and
tighten down until snug. DO NOT overtighten. Check for
leaks after the trim pump is bled (Step 11 on pages 46-47
in this manual).
Step 7: Trim Cylinder Installation (continued)
FIGURE 7G
FIGURE 7F
FIGURE 7E
To Next Page
Loading...
