Korg opsix - Page 50

50
• LFO Wave List
SQR (Square)
SIN (Sine)
SA
W DOWN (Saw Down)
SA
W UP (Saw Up)
TRI (Triangle)
TRI4 (Step4 Triangle)
SAW6 DOWN (Step6 Saw Down)
SAW4 DOWN (Step4 Saw Down)
TRI6 (Step6 Triangle)
X.SAW DOWN (Exp. Saw Down)
X.TRI (Exp. Triangle)
GTR (
Guitar)
X.SAW UP (Exp. Saw Up)
S/H (Sample&Hold)
S.RND LVTIME (StepRnd: Lvl&Time)
S.RND TIME (StepRnd: Time)
RND LEVEL (Random: Level)
RND LVTIME (Random:Lvl&Time)
RND TIME (Random:Time)
TRI+ (Triangle +)
SAW DOWN+ (Saw Down +)
SAW UP+ (Saw Up +)
SQR+ (Square +)
Take a look at the comments below on some of the waveforms.
GTR (Guitar):
is is for guitar vibrato. e value is positive only, and when it is set using pitch,
only a pitch bend up eect will result.
S/H (Sample&Hold):
is is a typical sample/hold waveform, on which the level changes at
random in xed intervals.
S.RND LVTIME (StepRnd: Lvl&Time):
Randomly changes the level and timing.
S.RND TIME (StepRnd: Time):
Generates a pulse wave at a random timing.
RND LEVEL (Random: Level), RND TIME (Random: Time), RND LVTIME (Random:
Lvl&Time):
Dierent from step-based changes, these are smoothed versions of S/H, S.RND
TIME and S.RND LVTIME that create non-linear changes. Use these for gradual random
changes.
Triangle + ... Square +:
is outputs only positive values, as opposed to the waveforms from
Triangle to Square that output values from −1 to +1. is is useful when you want a cyclical
pitch-up or pitch-down eect.
SPEED
When TEMPO (Tempo Sync) is on, this sets the base LFO speed as a note length.
When TEMPO (Tempo Sync) is o, this sets the LFO speed in Hz.