EasyManuals Logo

Kramer KDS-SW2-EN7 User Manual

Kramer KDS-SW2-EN7
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Kramer Electronics Ltd.
KDS-SW2-EN7 Using KDS-SW2-EN7 Embedded Web Pages
32
KDS-SW2-EN7 Network Settings
The device enables performing the following actions:
Defining Interface Settings on page 32.
Defining IP Casting Mode Setting and TTL on page 33.
Managing TCP/UDP Ports on page 33.
Defining Interface Settings
Define interface settings for each of the Ethernet ports.
To define interface settings:
1. In the Navigation pane, Select Device Settings. The General tab in the Device Settings
page appears (see Figure 18).
2. Select the Network tab. The Network tab appears.
Figure 19: Device Settings Page Network Tab
3. Set the Media port Stream service parameters:
DHCP mode Set DHCP to On (default) or Off.
IP Address When DHCP mode is set to Off, the device uses a static IP address.
This requires entering mask and gateway addresses.
Mask Address Enter subnet mask.

Other manuals for Kramer KDS-SW2-EN7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kramer KDS-SW2-EN7 and is the answer not in the manual?

Kramer KDS-SW2-EN7 Specifications

General IconGeneral
BrandKramer
ModelKDS-SW2-EN7
CategoryMedia Converter
LanguageEnglish

Related product manuals