Kramer VS-42UHD - Page 66

VS-42UHD - Protocol 3000 61
13.3.4.2 NET-DHCP
Functions Permission Transparency
Set:
NET-DHCP
Administrator Public
Get:
NET-DHCP?
End User
Public
Description Syntax
Set: Set DHCP mode
#NET-DHCPSP
mode
CR
Get: Get DHCP mode
#NET-DHCP?CR
Response
~nn@NET-DHCPSP
mode
CR LF
Parameters
mode – 0 (do not use DHCP. Use the IP address set by the factory or the NET-IP command), 1 (try to
use DHCP. If unavailable, use the IP address set by the factory or the
NET-IP
command)
Response Triggers
Notes
Connecting Ethernet to devices with DHCP may take more time in some networks
To connect with a randomly assigned IP by DHCP, specify the device DNS name (if available) using the
NAME command. You can also get an assigned IP by direct connection to USB or RS-232 protocol port if
available
Consult your network administrator for correct settings
K-Config Example
Enable DHCP mode, if available:
“#NET-DHCP 1”,0x0D