Enabling ARC Input
This section contains information on setting ARC mode using webpages. For information on
setting ARC mode using front panel buttons, see Operating in ARC Mode on page 17.
All Inputs can be configured to accept ARC signals. When ARC-enabled you can select the
audio output source.
To enable the ARC input:
1. In the Navigation pane, click Switching.
The Switching page appears (Figure 18).
2. Select the AFV tab.
The Audio-follow-video tab is displayed (Figure 18).
3. Click on an input button (Figure 19).
The input settings window appears (Figure 21):
4. Slide ARC/Step-in to ARC mode.
5. Click (the settings button).
The input ARC Settings window appears (by-default the output source is set to output 1):
Figure 23: Input 3 ARC Settings
6. Select the desired HDMI output (for example, 6).
Figure 24: Select ARC Output Source
7. Click to close the window.
Output 6 is set to be the ARC source for input 3.
Note that output 6 also needs to be checked in the Audio break away window for it to pass
through to input 3 in this example.
To Next Page
Loading...
