Krone X-Disc 620 - Page 4

Foreword
4
5.4 Parking the machine......................................................................................................................... 32
5.5 Adjusting machine to the forage harvester BiG X 480/580 .............................................................. 33
5.5.1 Adjusting the locking plates ...................................................................................................... 34
5.5.2 Adjusting the main angular gearbox ......................................................................................... 36
6 Start-up .................................................................................................................................................. 39
6.1 Checking and Observing Before Start-Up ........................................................................................ 39
6.2 Attachment to the forage harvester .................................................................................................. 40
6.2.1 Adapter Frame .......................................................................................................................... 40
6.2.2 Parking supports in transport position on the right/left .............................................................. 42
7 Driving and Transport .......................................................................................................................... 43
8 Operation ............................................................................................................................................... 45
8.1 From transport into working position ................................................................................................ 45
8.1.1 Working Position ....................................................................................................................... 45
8.2 Detaching the machine .................................................................................................................... 47
9 Settings ................................................................................................................................................. 49
9.1 Adjusting the distance between the scraper bars and the auger conveyor ..................................... 50
9.1.1 Set Ground Skid ........................................................................................................................ 51
9.2 Setting Infeed Sheets ....................................................................................................................... 51
10 Maintenance .......................................................................................................................................... 53
10.1 Special Safety Instructions ............................................................................................................... 53
10.1.1 Test run ..................................................................................................................................... 53
10.2 Spare Parts ...................................................................................................................................... 53
10.3 Maintenance table ............................................................................................................................ 54
10.4 Tightening torques ............................................................................................................................ 55
10.4.1 Metric Thread Screws with Control Thread .............................................................................. 55
10.4.2 Metric Thread Screws with Fine Thread ................................................................................... 56
10.4.3 Metric Thread Screws with Countersunk Head and Hexagonal Socket ................................... 56
10.5 Main angular gearbox ...................................................................................................................... 57
10.6 L corner gearbox .............................................................................................................................. 58
10.7 Cutter bar drive gear ........................................................................................................................ 59
10.8 Oil level check and oil change on the cutter bar .............................................................................. 60
10.8.1 Oil change ................................................................................................................................. 60
10.8.2 Checking the oil level ................................................................................................................ 60
10.8.3 Aligning the Cutter Bar .............................................................................................................. 60
10.9 Checking the Cutter Blades and Blade Holder ................................................................................ 62
10.9.1 Cutter Blades ............................................................................................................................ 62
10.9.2 Blade screw connection ............................................................................................................ 63
10.9.3 Blade Quick-Fit Device ............................................................................................................. 64
10.9.4 Periodical Inspection of the Leaf Springs ................................................................................. 65
10.9.5 Periodical Inspection of the Cutting Discs / Blade Drums ......................................................... 66
10.9.6 Abrasion Limit ........................................................................................................................... 67
10.10 Blade Changing on Cutting Discs .................................................................................................... 68
10.10.1 Blade Screw Connection ........................................................................................................... 69
10.10.2 Blade Quick-Fit Device ............................................................................................................. 70
10.11 Replacing the linings ........................................................................................................................ 71
10.12 Rotary hub with shear fuse (optional) .............................................................................................. 72
10.12.1 After Shearing Off ..................................................................................................................... 74
10.13 Wear Sheets for Trough ................................................................................................................... 76