Krone X-Disc 620 - 3 Safety; Purpose of Use; Intended Use; Service Life of the Machine

Safety
9
Pos: 17.1 /Überschri ften/Überschri ften 1/P-T/Sicherhei t @ 0\mod_1195566748646_7 8.docx @ 635 @ 1 @ 1
3 Safety
Pos: 17.2 /Überschri ften/Überschri ften 2/U-Z/Verwendungs zweck @ 1\mod_12017072467 38_78.docx @ 54055 @ 2 @ 1
3.1 Purpose of Use
Pos: 17.3 /BA/Einlei tung/Vorsätze/Ver wendungszweck X-Di sc 620 @ 328\mod_14266000938 92_78.docx @ 2513157 @ @ 1
The direct cutting system of the X-Disc 620 series is a header especially for the KRONE forage
harvester BiG X. It is used to cut thin crops growing on the ground.
Pos: 17.4.1 /Überschr iften/Überschr iften 2/A-E/Bestimmungs gemäßer Gebrauch (al t) @ 0\mod_1196401545090 _78.docx @ 7728 @ 2 @ 1
3.2 Intended Use
Pos: 17.4.2 /BA/Ei nleitung/Bestimmungsg emäßer Gebrauch/Vor sätze/Bestimmungsge mäßer Gebrauch X-D isc @ 12\mod_1224575491250_78. docx @ 151478 @ @ 1
The direct cutting system may be attached only to carrier vehicles for which the relevant adapter
frame is released (observe operating permission of the carrier vehicle). It is built exclusively for
customary use in agricultural work (intended use) - see also Introduction chapter entitled
"Purpose of Use".
Pos: 17.4.3 /BA/Ei nleitung/Bestimmungsg emäßer Gebrauch/Nic ht bestimmungsgemäß @ 103\ mod_1332171672294_7 8.docx @ 940272 @ @ 1
Unauthorised modifications to the machine may have a negative effect on the machine
characteristics or safe and reliable use of the machine or may interfere with proper operation.
Unauthorised modifications shall therefore release the manufacturer of any liability for
consequential damage.
Pos: 17.5 /Überschri ften/Überschri ften 2/K-O/Nutzungsda uer der Maschine @ 318\mod_1423 658430909_78.doc x @ 2465744 @ 2 @ 1
3.3 Service life of the machine
Pos: 17.6 /BA/Einlei tung/Nutzungsdauer der Maschine_Text @ 318\m od_1423556613022_78.d ocx @ 2463145 @ @ 1
– The service life of this machine strongly depends on proper use and maintenance as well as
the operating conditions.
– Permanent operational readiness as well as long service life of the machine can be
achieved by observing the instructions and notes of these operating instructions.
– After each season of use, the machine must be checked thoroughly for wear and other
damage.
– Damaged and worn parts must be replaced before placing the machine into service again.
– After the machine has been used for five years, carry out full technical inspection of the
machine. According to the results of this inspection, a decision concerning the possibility of
reuse of the machine should be taken.
– Theoretically, the service life of this machine is unlimited as all worn or damaged parts can
be replaced.
Pos: 17.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_119617531122 6_0.docx @ 4165 @ @ 1