Operation
45
Pos: 53.1 /Überschri ften/Überschri ften 1/A-E/Bedienung @ 0\mo d_1199789505403_78.doc x @ 34825 @ 1 @ 1
8 Operation
Pos: 53.2 /Überschri ften/Überschri ften 2/U-Z/Von Transport i n Arbeitsstellung @ 2\ mod_1202466185276_78. docx @ 59662 @ 2 @ 1
8.1 From transport into working position
Pos: 53.3 /BA/Sic herheit/7. Gefahrenhin weise alt/Vorsätze/ Gefahr - Absenken des Vorsa tzes @ 15\mod_1232708075 710_78.docx @ 1762 50 @ @ 1
Danger! - Lowering the machine into working position
Effect: Danger to life, injuries or damage to the machine.
• Do not lower the machine until you are absolutely sure that neither persons, animals nor
objects are in the swivel range of the machine.
• Keep persons out of the danger zone. If persons do approach the danger zone, turn off the
machine immediately.
• Never leave the machine running unsupervised.
• Check the safety devices each time before the machine is used. Replace damaged safety
devices immediately.
• Do not work on the front attachment until the engine has been stopped and the ignition key
has been removed. All operating levers should be in the neutral position and no hydraulic
lines should be under pressure.
• Always check the attachment before use and after driving into an obstacle. Worn, damaged
or deformed blades must be replaced immediately. This also applies to holders.
• Do not switch on the drive until the front attachment is in the working position.
Pos: 53.4 /BA/Bedienung / Vorsätze/Schneid werk/Arbeitsste llung X-Disc 620 @ 336\mod_14 30201826316_78.doc x @ 2559295 @ 3 @ 1
8.1.1 Working Position
Fig. 20
Lower the cutting system (1) down to the ground.
Note
• Check guard cloth (2) and rubber strip (3) (right-hand and left-hand machine side) before
every use. Replace damaged safety devices (2, 3) immediately.
Pos: 53.5 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_119617531122 6_0.docx @ 4165 @ @ 1
To Next Page
Loading...
