Operation
46
Pos: 53.6 /BA/Bedienung / Vorsätze/Schneid werk/Fahren im Vorge wende @ 68\mod_130441595891 6_78.docx @ 627273 @ @ 1
Driving in headland position:
• Set the lifting height to max. 40 cm via the display of the forage harvester (see operating
instructions of the forage harvester, chapter "Lifting Gear" - Setting and Securing Lifting
Height for the Headland Position)
DANGER! – Rapidly rotating cutting discs/blade drums
Effect: Danger to life or serious injuries.
• For mowing, the lifting height of the cutting system must be set to max. 40 cm (measured
between ground and cutter bar front edge).
• Set the ground pressure to between 3 % and 5 % via the display on the forage harvester
(see operating instructions of the forage harvester info centre, chapter "Lifting Gear")
Note
The lower the bearing pressure, the lower the wear at the ground skids.
Pos: 53.7 /BA/Bedienung / Vorsätze/Schneid werk/Antriebsdreh zahl 750 beachten @ 12\mod _1224742253248_78.doc x @ 153193 @ @ 1
DANGER! – Observe drive speed
Effect: Danger to life or serious injuries
• Do not exceed the maximum drive speed of 750 rpm.
Pos: 53.8 /BA/Bedienung / Vorsätze/Schneid werk/Schneidwerk ein setzen @ 12\mod_1224742 534795_78.doc x @ 153282 @ @ 1
• Set max. drive speed (750 rpm) of the front attachment drive on the forage harvester
via the display (see operating instructions for the forage harvester).
• Switch on cutting drum (see operating instructions for the forage harvester).
• Switch on drive of the cutting system / feed drive rollers.
• Drive into the crop with the forage harvester.
• The driving speed depends on the particular application conditions (ground conditions, the
height and nature of the crop).
Pos: 53.9 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_119617531122 6_0.docx @ 4165 @ @ 1
To Next Page
Loading...
