Krone X-Disc 620 - 11 Maintenance - Lubrication Chart; Special Safety Instructions; PTO Shaft

Maintenance – lubrication chart
78
Pos: 59.35.1 /Überschr iften/Überschr iften 1/U-Z/War tung - Schmierplan @ 0\mod_119735 9304198_78.doc x @ 18232 @ 1 @ 1
11 Maintenance – lubrication chart
Pos: 59.35.2 /Überschr iften/Überschr iften 2/P-T/Speziel le Sicherheitshin weise @ 0\mod_119666049576 0_78.docx @ 9134 @ 2 @ 1
11.1 Special Safety Instructions
Pos: 59.35.3 /BA/Si cherheit/7. Gefahr enhinweise alt/Vorsät ze/Gefahr War tung allgemein Vorsätze/Fel dhäcksler (Messerte ller) @ 13\mod_122545355 5895_78.docx @ 156385 @ @ 1
Danger! - When performing repair, maintenance or cleaning work or when making
technical modifications to the machine, drive elements may start moving (caution:
cutting discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Move the machine to the working position and lower it to the ground
• Switch off the forage harvester engine and remove the ignition key.
• Secure the forage harvester against accidental start-up and against rolling away.
• Switch off the PTO and disengage it.
• After the repair, maintenance, cleaning work or technical modifications are completed,
mount all protective covers and protective devices properly again.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents, contact a doctor
immediately.
• All other safety instructions must also be followed to avoid injuries and accidents.
Pos: 59.35.4 /Überschr iften/Überschr iften 2/F-J/Gelenk welle @ 0\mod_11997818797 94_78.docx @ 34542 @ 2 @ 1
11.2 PTO shaft
Pos: 59.35.5 /BA/W artung/Gelenkwelle sch mieren/Abschmiere n Gelenkwellen X-Disc 620 @ 337\mod_1430211329598_ 78.docx @ 2559749 @ @ 1
GPS00060
250 h
100 h
Fig. 47
Lubricate the universal shafts with multi-purpose grease at the intervals indicated in the figure.
Follow the operating instructions of the universal shaft manufacturer.
Pos: 59.35.6 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.d ocx @ 4165 @ @ 1