14 ELECTRICAL SYSTEM 124
100160-10
Main work
– Remove the screw on the rear of the turn signal housing.
– Carefully swing turn signal glass 1 forward and take it off.
– Press the turn signal bulb carefully into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
– Press the new turn signal bulb carefully into the socket and turn it clockwise until it
stops.
Turn signal (RY10W / socket BAU15s) ( p. 167)
– Position the turn signal glass.
– Insert the screw and turn it counterclockwise first until it engages in the thread. Tighten
the screw slightly.
Finishing work
– Check the turn signal system function.
14.11 Checking the headlight setting
400726-10
– Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
– Make another mark at a distance B under the first mark.
Guideline
Distance B 5 cm (2 in)
– Position the vehicle vertically at a distance A in front of the wall.
Guideline
Distance A 5 m (16 ft)
To Next Page
Loading...
