11 SERVICE WORK ON THE CHASSIS 80
601883-10
Main work
– Loosen nut 1.
– Loosen nuts 2.
– Adjust the chain tension by turning adjusting screws 3 on the left and right.
Guideline
Chain tension 5 mm (0.2 in)
Turn the left and right adjusting screws 3 so that the markings on the left and right
chain adjusters 4 are in the same position relative to the reference marks C. The
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
– Tighten nuts 2.
– Make sure that the chain adjusters 4 are installed correctly on adjusting screws 3.
– Tighten nut 1.
Guideline
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
11.19 Check the chain, rear sprocket, engine sprocket, and chain guide
Preparatory work
– Raise the motorcycle with the rear wheel stand. ( p. 68)
To Next Page
Loading...
