10 TUNING THE CHASSIS 66
10.9 Adjusting the handlebar position x
601875-10
– Remove the four screws 1. Remove the handlebar clamps. Take off the handlebar and
set it aside.
Info
Cover the motorcycle and attachments to protect them from damage.
Do not kink the cables and lines.
– Remove the two screws 2. Take off the handlebar holder.
– Move the handlebar holder to the desired position. Mount and tighten the two
screws 2.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the handlebar holders evenly on the left and right.
– Position the handlebar.
Info
Ensure that the cables and lines are routed correctly.
– Position the handlebar clamps. Mount and evenly tighten the four screws 1.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
To Next Page
Loading...
