KTM 690 SMC R EU - 9 Service Schedule

9 SERVICE SCHEDULE 57
9.1 Service schedule
K10N K100A K200A
Check that the electrical equipment is functioning correctly. • • •
Read out the fault memory using the KTM diagnostics tool. x
• • •
Check the measured service values with the KTM diagnostics tool. x
• •
Change the engine oil and filter, clean the oil screens. x ( p. 139)
• • •
Check the front brake linings. ( p. 89) • • •
Check the rear brake linings. ( p. 94) • • •
Check the brake discs. ( p. 86) • • •
Check the brake lines for damage and leakage. • • •
Check the rear brake fluid level. ( p. 92) • • •
Check the free travel of the foot brake lever. ( p. 90) • • •
Check that the shock absorber and fork are leak tight. If necessary and depending on use, service the fork
and shock absorber.
• • •
Check the swingarm bearing. x
• •
Check the wheel bearing for play. x
• •
Check the tire condition. ( p. 104) • • •
Check the tire air pressure. ( p. 106) • • •
Check the spoke tension. ( p. 107) • • •
Check for rim run-out. x
• • •
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 80) • •
Check the chain tension. ( p. 78) • • •
Grease all moving parts (e.g. side stand, hand lever, chain, ...) and check for smooth operation. x
• • •
Clean the dust boots of the fork legs. ( p. 71) • •