KTM 690 SMC R EU - 11.8 Cleaning the dust boots of the fork legs

11 SERVICE WORK ON THE CHASSIS 71
601879-10
Main work
– Briefly loosen bleeder screws 1.
Any excess pressure escapes from the interior of the fork.
– Mount and tighten bleeder screws.
Info
Carry out this action on both fork legs.
11.8 Cleaning the dust boots of the fork legs
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 67)
– Remove the fork protector. ( p. 72)
L00350-10
Main work
– Push dust boots 1 on both fork legs downward.
Info
The dust boots remove dust and coarse dirt particles from the inside fork tubes.
Over time, dirt can penetrate behind the dust boots. If this dirt is not removed,
the oil seals behind the dust boots can start to leak.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the
brake discs.
– Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.