KTM 690 SMC R EU - 11.21 Checking;rectifying the fluid level of the hydraulic clutch

11 SERVICE WORK ON THE CHASSIS 83
401171-01
– Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding piece:
–
Change the chain sliding piece. x
– Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
– Tighten the chain sliding piece.
Guideline
Screw, chain sliding piece M8 15 Nm
(11.1 lbf ft)
400985-01
– Check the chain guide for wear.
Info
Wear is visible on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide. x