KUHN GMD310 - Page 108

GMD240 - 280 - 310
108
12. - Appendix
KN204BGB_G
Disc mower
 Front tool:
2) Calculation of the minimum front ballast weight M2
minimum
- Write the minimal additional weight in the chart.
3) Calculation of the actual load on the front axle T1
real
If the front tool (M1) is lighter than the minimum load required at the front (minimum), increase tool weight
until the required minimum front load is reached
- Indicate front axle calculated load value and the one indicated in the tractor operators' manual.
4) Calculation of the total weight M
real
If the rear tool (M2) is lighter than the minimum load required at the rear(minimum), increase tool weight
until the required minimum rear load is reached
Indicate calculated total load value and the one authorized as indicated in the tractor operator's manual.
5) Calculation of the actual rear axle load T2
real
Indicate rear axle calculated load value and the one indicated in the tractor operator's manual.
6) Tyre carrying capacity
Indicate double (2 tyres) the authorized load value (see tyre manufacturer indications).
M2minimum
M1 aT2 b 045 Tb+–
bcd++
---------------------------------------------------------------------------- -
=
M2
minimum
T1reel
M1 ab+T1 bM2 cd+––
b
-------------------------------------------------------------------------------------------
=
T1
real
M1 TM2++=
M
real
T2
real =
M
real
-
T1
real