10. - Maintenance and storage
GMD240 - 280 - 310
95
KN204BGB_G
Disc mower
- Replace spring plate in the following cases:
• When there is visible distortion.
• When you have noticed substantial wear on a
spring plate: Width B of a spring plate, measured
at A = 20 mm (0.8’’), must exceed 60 mm (2.4’’).
- See section: Maintenance and storage /
Maintenance / Spring plate replacement.
Knife replacement
Before carrying out any maintenance or
repairs on the machine, switch off the tractor
engine, remove ignition key, wait until all
moving parts have come to a standstill and
apply park brake.
Replace immediately all worn or distorted
knives.
Never straighten a bent knife.
- Always replace both knives per disc.
To Next Page
Loading...
