GMD240 - 280 - 310
96
10. - Maintenance and storage
KN204BGB_G
Disc mower
Removal:
- Clean the top side of the disk guard.
- Clean cavities between disc and spring plate.
- Slightly hit all ground residues between the
knife and the screw with a mallet to remove
them.
- Fully insert special tool between disc and spring
plate.
- Pivot special tool downwards to free spring plate
from screw head.
- Make sure that the securing nut and bolt are in
good condition and if necessary, replace them:
• Torque: 12.3 daNm (91 lbf ft).
Dull knives require more horse power and have a
negative effect on the cut quality.
To Next Page
Loading...
