10-16
Troubleshooting > Troubleshooting
Cannot print. Is the machine plugged in? Plug the power cord into an AC
outlet.
―
Is the machine powered on? Turn on the power switch. page 2-11
Are the USB cable and network
cable connected?
Connect the correct USB cable and
network cable securely.
page 2-9
Is the print job paused? Resume printing. page 7-2
When the wired or Wi-Fi network is
configured using the name
resolution, does the IP address
(private address) of the other
network which can not access
coexists?
The number of host name and
domain name which can be used
with the machine is one
respectively. Configure the network
under this restriction.
―
Change the settings of name
resolution such as NetBEUI and
DNS, or network environment
settings.
Command
Center RX
User
Guide
Select Wi-Fi, Wired Network or
Optional Network as an unlimited-
use network on Primary Network
(Client).
page 8-55
Set to [Wired Network] or [Wi-Fi]
either one of [On], and set the other
setting to [Off].
page 8-55
Cannot print with USB
drive.
USB drive not
recognized.
Is the USB host blocked? Select [Unblock] in the USB host
settings.
page 8-56
― Check that the USB drive is
securely plugged into the machine.
―
While "Auto-IP" is already
set to [On], the IP
address is not assigned
automatically.
Is a value other than "0.0.0.0"
entered for the link local address of
TCP/IP(v4)?
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
page 2-36
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General