FS-1900
5-4
5-2 Disassembly
5-2-1 Removing the developer
(1) Removing the developer
CAUTION When if installing or removing the developer, do not let the magnet roller touch
any part in the printer.
When handling developer, use both hands. Do not press the bottom of the
developer.
1. Open the top cover.
2. Remove the toner container.
3. Disconnect the developer connector 1.
4. Remove the developer 2 from the printer while sliding the developer lock lever 3 frontwards.
Figure 5-2-1 Removing the developer
1
2
2
3
To Next Page
Loading...
