Kyocera FS-1900 - Drum Cleaning Mode

3-16
FS-1900
(7) Drum cleaning mode
This mode enforces the printer to rotate the drum against the cleaning roller inside the drum unit for
a predetermined period of time. The cleaning roller then removes dust and debris that may have
resulted from dew condensation on the drum.
The printer automatically activates the drum cleaning mode based on the environmental conditions
as the temperature/humidity sensor detects. The time required to complete the drum cleaning mode
varies depending on the current setting for the sleep timer and will be deactivated during the developer
initialization.
The drum cleaning mode is also activated manually by following the steps below:
Perform in sequence Display to show Remarks
1 Press the MENU key.
2 Press the key (repeatedly).
3 Press the > key.
4 Press the key. (repeatedly).
5 Press the > key.
6 Press the key. (repeatedly).
7 Press the ENTER key.
8 Press the ENTER key.
Drum is cleaned by the cleaning
blade in the drum unit. If paper is
present on the MP tray, the drum
is also cleaned by that the paper
which is fed automatically and
stops at the transfer roller.
Others >
>Service >
>>Drum
>>Drum?