FS-1900
5-34
(3) Removing the heat roller
WARNING The heat roller is extremely hot immediately after the printer was running. Allow
a substantial period of time until it cools down.
1. Remove and split the fuser unit. See page 5-29.
2. Remove the heater lamp. See the previous page.
3. Remove the separators. See page 5-32.
4. Pull up both heat R bush 1 and heat L bush 2 at the same time.
5. Remove heat gear Z36 3, heat R bush 1, and heat L bush 2 from the heat roller 4.
1
2
4
3
Figure 5-2-31 Removing the heat roller
To Next Page
Loading...
