2-22
FS-1900
(5) Message display
The message display gives information in the form of short messages. The six messages listed
below are displayed during normal warm-up and printing. Other messages appear when the printer
needs the operator's attention as explained in Chapter 6 Troubleshooting.
Message Meaning
Self test
Please wait
Ready
Processing
Waiting
Sleeping
Cancelling data
FormFeed Time Out
The printer is self-testing after power-up.
The printer is warming up and is not ready. When the printer is
switched on the first time after the toner container is installed,
(Adding toner) also appears.
The printer is ready to print.
The printer is receiving data, generating graphics, reading an memory
card (CompactFlash)/hard disk (Microdrive), or printing.
The printer is waiting for a command that says the job is over before
printing the last page. Pressing the GO key allows you to obtain the
last page immediately.
The printer is in Sleep mode. The printer wakes from Sleep mode
whenever a key on the operator panel is pressed, the cover is opened
or closed, or data is received. The printer then warms up and goes
on-line. (The time that it takes the printer to enter Sleep mode depends
on the Sleep Timer setting.)
Data inside the printer is being canceled.
The printer prints the last page after a waiting period.
To Next Page
Loading...
