FS-1900
5-33
(2) Removing the heater lamp
WARNING The heater lamp is extremely hot immediately after the printer was running. Allow
substantial period of time until it cools down.
CAUTION The heater lamps are fragile. Use extreme care when handling not to drop or
break.
Do not directly touch on the heater lamp. Finger prints on the heater lamp’s outer
surface can prevent proper fusing of toner on paper. When holding the heater
lamp, hold the ceramic parts of heater lamp at both ends.
When refitting the heater lamp, direct the wattage making side facing the gear
side.
1. Remove and split the fuser unit. See page 5-29.
2. Remove the lamp support 1.
3. Remove one screw 2 then remove the lamp holder 3.
4. Remove the heater lamp 4 from the heat roller 5.
Figure 5-2-30 Removing the heater lamp
4
2
3
5
1
Wattage marking
Gear
To Next Page
Loading...
