6-7
FS-1900
Message Corrective action
Call service
person F0
Call service
####
Call service
####:0123456
File not found
Press GO
Format error
Memory Card
Format error
Hard disk
Hard disk error##
Press GO
: Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
The ATTENTION indicator turns on and the READY indicator goes
off. Indicates a problem with the controller and the operator panel.
Call a service person. The printer does not operate when this message
is displayed. (Refer to section 6-1-2 Diagnostic (Service error
message) on page 6-11.)
The ATTENTION indicator turns on. Indicates a controller error. Call
a service person. The printer does not operate when this message is
displayed. (Refer to section 6-1-2 Diagnostic (Service error message)
on page 6-11.)
The ATTENTION indicator turns on. Indicates a mechanical error.
Call a service person. 0123456 indicates the number of printed pages.
(Refer to section 6-1-2 Diagnostic (Service error message) on page
6-11.)
VMB: A VMB tray that was specified for output does not contain any
jobs, or the VMB tray is not being used. Confirm the VMB tray.
If Auto Continue is set to On, printing will be automatically
resumed after a preset period of time. Refer to printer’s User’s Manual.
This message appears when the printer is in the ready state and the
memory card (CompactFlash) is not formatted, and therefore cannot
be read or written. Refer to printer’s User’s Manual.
Initialization (formatting) of the hard disk is required. Initialize the
hard disk (Microdrive). Refer to printer’s User’s Manual.
Look at the error code given in place of ## and refer to the
corresponding description given below.
01: Hard disk (Microdrive) format error. If this error recurs even if
the power has been turned off and then on, reformat the hard disk.
02: The disk system is not installed. Recheck the requirements for
using the system and the devices.
04: There is no available hard disk (Microdrive) space. Delete
unnecessary files, etc., in order to free up space.
05: The specified file does not exist in the hard disk (Microdrive).
06: There is no memory available to the hard disk (Microdrive) system.
Increase the available memory.
(2) Error messages
To Next Page
Loading...
