Kyocera FS-1900 - Page 158

6-8
FS-1900
Message Corrective action
Hard disk error##
Press GO
I/F occupied
ID error
Insert the same
memory card
KPDL Error ##
Press GO
Memory card err
Insert again
: Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
10: Formatting is not possible because host data is being spooled on
the hard disk (Microdrive). Wait until the hard disk is ready, and then
format.
85: VMB. Alias error (The alias setting was lost, or the VMB tray
corresponding to the alias does not exist.) Set alias again.
97: Code job. The number of permanent code job reached the limit
value, and no more can be saved. Either delete some unnecessary jobs,
etc., or increase the limit.
99: A print job for the specified ID does not exist in the hard disk
(Microdrive).
This message is displayed when you attempt to use the printer's operator
panel to change the environmental settings on the interface from which
data are presently being received.
The ID entered for a private job, or a stored job is not correct. Check
the ID that is set using the printer driver.
You have inserted a wrong memory card (CompactFlash) when the
Insert again message was displayed. Remove the wrong memory
card from the printer's memory card slot and insert the correct memory
card. The printer again reads it from the beginning of the data.
PostScript error has occurred and current print processing cannot
continue. To print out an error report, display > Print KPDL errs
from the menu selection system, and select On. Press the GO key to
resume printing. You can abandon printing by the CANCEL key.
If Auto Continue is set to On, printing will be automatically resumed
after a preset period of time. Refer to printer’s User’s Manual.
The memory card (CompactFlash) is accidentally removed from the
printer's memory card slot during reading. If you continue reading the
memory card, insert the same memory card into the slot again. The
printer again reads it from the beginning of the data.
Note: We recommend that you follow the reading procedure from the
beginning to ensure correct reading of the memory card.