FS-1900
5-26
(5) Removing the sensor board
CAUTION Draw the connector straight to remove. If you draw the connector while it is
slanted, the receptacle may be damaged.
1. Remove the drum unit. See page 5-12.
2. Remove the high voltage unit. See previous page.
3. Remove two connectors 1.
4. Remove the high voltage unit cover 2.
5. Remove the sensor board 3 while unlatching two latches A.
Figure 5-2-23 Removing the sensor board
3
1
2
A
A
1
Connector
Connector
Receptacle
Receptacle
To Next Page
Loading...
