Kyocera FS-1900 - Downloading Errors

3-23
FS-1900
(4) Downloading errors
The following messages are indicated on the message display when an error occurred during
downloading the firmware data.
Error message Description Corrective action
##: Error code 20 to 26.
##: Error code 40 to 59.
##: Error code 80 or 81.
##: Error code 60 or 69.
##: Error code 70 or 77.
Deficit of the file header
Deficit of the data header
File checksum error
Data checksum error
File header version error
Data header version error
Incompatibility of firmware and
system DIMM board
Defective system DIMM board
Improper connection of parallel cable
between PC and printer
Defective parallel cable
Improper connection of parallel cable
between PC and printer
Incompatibility of firmware and engine
board
Improper connection of parallel cable
between PC and printer
Defective LCD controller board
Obtain the correct firmware.
Confirm whether the firmware
is applicable to this printer.
Replace the system DIMM
board.
Check the contact between PC
and the printer’s interface
connector.
Replace the parallel cable.
Check the contact between PC
and the printer’s interface
connector.
Confirm whether the firmware
conforms to this printer.
Check the contact between PC
and the printer’s interface
connector.
Replace the LCD controller
board
download header
error [##]
system download
error [##]
receive
error [##]
If the corrective action above does not solve the problem, replace engine board (KP-864). See page
5-22.
Engine download
error [##]
Message download
error [##]