Kyocera FS-1900 - Removing the Thermistor and the Thermal Cutout

FS-1900
5-35
(4) Removing the thermistor and the thermal cutout
1. Remove and split the fuser unit. See page 5-29.
2. Remove the heater lamp. See page 5-33.
3. Remove the heat roller. See previous page.
4. Remove one screw 1.
5. Remove the thermistor 2.
6. Remove two screws 3 and then remove cord plate 4.
7. Remove one screw 5 and the heater wire terminal 6.
8. Remove the thermal cutout 7.
Figure 5-2-32 Removing the thermistor and thermal cutout
6
7
5
4
3
1
2