Kyocera FS-1900 - Removing the Drive Unit and Main Motor

FS-1900
5-27
5-2-10 Removing the drive unit and main motor
CAUTION Draw the connector straight to remove. If you draw the connector while it is
slanted, the receptacle may be damaged.
1. Remove the paper cassette and the paper transfer unit. See page 5-6.
2. Remove the top cover/face-down output tray. See page 5-9.
3. Remove the left and right covers. See pages 5-10 and 5-11.
4. Remove two connectors 1.
5. Remove three connectors 2 of the drive unit 3.
6. Remove five screws 4 and the ground wire terminal 5.
7. Remove the drive unit 3 from the frame unit.
Figure 5-2-24 Removing drive unit
4
5
3
1
2
4
Connector
Connector
Receptacle
Receptacle