3-22
FS-1900
5 Data are transferred to the RAM on the main board.
6 The system DIMM or Flash ROM is overwritten with the new firmware data.
7 Firmware download is finished. (When more than one data are down loaded, the data display
can be changed by pressing any key.
8 Turn power switch off.
9 Remove the memory card.
0 Turn power switch on.
! Check the printer gets Ready.
Confirm that the status page shows the new engine firmware, system firmware or operator panel
message data version (See Appendix B on page B-4). If the message display indicates download
error, refer to section Downloading errors on page 3-23.
Supervisor mode
CF-CARD Reading
BootROM
erase&write
engine download
<<<<<<<<<<<
message download
<<<<<<<<<<<
DIMM erasing #??
Ready
Power switch: Off
Power switch: On
Spanish 04
01/10/18[1234] 2
B
A
BBGC
EF
EF EF
D
G G
01 A002
01/10/18[1234] 2
84.00S
01/10/18[1234] 2
A: u= Extracting
W= Writing
V= Verifiying
B: Version
C: Machine code
D: Language
E: Year/Month/Day
F: [Checksum]
G: Means more than one data
End
DIMM writing
<<<<<<<<<<u
S
E
M
77 7
8
!
0
4
5
666
Memory
card
9
From the previous page
Supervisor mode
Message display
: System firmware
: Engine firmware
: Operator panel message data
S
E
M
: Shows only included firmeware
of boot program (".bcmp" extension file).
To Next Page
Loading...
