2DF
1-3-37
12. Fasten the NCU unit into place from the
bottom with two M3 × 06 chrome binding
screws.
13. Connect the three connectors from the NCU
board to the corresponding connectors on the
fax board, as follows:
• Speaker 2-pin connector → CN7
• NCU board connector → CN3
• Battery connector → CN6
14. Remove the film that fixes the three positive
connectors of the power source PCB from the
optional interface mounting plate.
Important: Dispose of the film that has been
removed.
Figure 1-3-70
Figure 1-3-70-1
NCU unit
Speaker
2-pin connecto
NCU board
M3 × 06 chrome
binding screws
CN7
CN6
CN3
Battery
connector
NCU board
connector
Film
Optional interface
mounting plate
To Next Page
Loading...
