To Next Page

To Previous Page

Important Safety Instructions

PLM Series Operation Manual rev 1.1.9

1.4 WARNING

To reduce risk of re or electric shock, do not expose this apparatus to rain or moisture.

Pour réduire les risques de blessure ou le choc électrique, n’exposez pas l’appareil à la pluie ou à l’humidité.

Do not expose this system/apparatus to dripping or splashing and ensure that no objects lled with liquids, such

as vases, are placed on the apparatus.

L’appareil ne doit pas être exposé à des egouttements d’eau ou des éclaboussures et de plus qu’aucun objet

rempli de liquide tel que des vases ne doit pas être placé sur l’appareil.

This apparatus must be connected to a mains socket outlet with a protective earthing connection.

Cet appareil doi t être raccordé á une prise de courant qui est branchée à la terre.

The mains plug is used as a disconnect device and shall remain readily operable.

Lorsque la prise du réseau d’alimentation est utilisés comme dispositif de déconnexion, ce dispositif doit

demeuré aisément accessible.

1.5 CAUTION

To reduce the risk of re or electric shock, do not remove screws. No user-serviceable parts inside.

Refer servicing to qualied service personnel.

Pour réduire le risque d’incendie ou de choc électrique, ne pas retirer les vis. Aucune pièce réparable par

l’utilisateur. Coner l’entretien àpersonnel qualié.

1.6 FCC Compliance Notice (Radio Interference)

A sample of this product has been tested and complies with the limits for the European Electro Magnetic

Compatibility (EMC) directive. This equipment has also been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference from electrical equipment. This product uses radio frequency energy

and if not used or installed in accordance with these operating instructions, may cause interference to other

equipment, such as radio receivers.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by turning the

equipment on and off, the user is encouraged to try to correct the interference by one or more of the

following measures:

▸ Reorient or relocate the antenna.

▸ Increase the separation between the equipment and receiver.

▸ Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Lab.gruppen PLM Series User Manual

Other manuals for Lab.gruppen PLM Series